This morning, after I sanded the second coat almost completely off, I still had a few low spots that just weren't filled enough. Soooo... will do a third coat and tomorrow I'll sand that one off too.
However, to ensure that I will truly fill the low spots, I did some spot filling on just those areas that needed it. Then a few hours later, I added a third coat to the entire hull. I also added some additional thickened epoxy to the fillet at the full/fin joint.
Here is how it looked after the sanding and the spot filling:
Here it is after the third coat has been added...
Tomorrow, I'll sand it for, hopefully, a last time, and then I may be able to cut it free from the strongback.
Aloha!
However, to ensure that I will truly fill the low spots, I did some spot filling on just those areas that needed it. Then a few hours later, I added a third coat to the entire hull. I also added some additional thickened epoxy to the fillet at the full/fin joint.
Here is how it looked after the sanding and the spot filling:
Here it is after the third coat has been added...
Tomorrow, I'll sand it for, hopefully, a last time, and then I may be able to cut it free from the strongback.
Aloha!
Comments
Post a Comment