Now back to the Wampum VM. I've spent the past couple weeks working on the 3D model and laser cut frames file for the Rip Tide HF, but today I was able to get the outer sheer rail on the Wampum installed. Yesterday I installed the inner rail. It all seemed to fit well, except for frame 6. I had to go back into my 3D model and adjust a portion of frame 6 out by about a 1/16". I've already made the adjustment on the frames file too, for future cuts. The aft portion of the sheer rails are required to have a very hard twist to them. It's taken a load of clamps and even some screw clamps to keep them twisted, but I think it will hold once the epoxy cures. At the bow, you need to bring the sheer rails in a bit from the front to leave room for the planks. More later! Aloha!