Today I used the laser cutter at work to cut sail numbers and insignia for my Sun Wind II wooden Vintage Marblehead sailboat. Turned out well! I used adhesive-backed insignia sailcloth . It even melted the edges a bit so they won't fray. My only concern is that the melting may have put a rough look onto the edges. The settings on the laser cutter were 100% speed and 1% power. I might try using even less power next time. The 1% didn't cut, or even scorch, the waxy paper underneath, but I'll do an experiment to see if .5% would more cleanly melt the edges. It's fun messing around in boats, and also laser cutters! I'll have to see how they look when I pull them all off. If they don't look good then I'll simply cut new ones by hand with a sharp hobby knife. Here is how the number 7 looked when I pulled off the surrounding material. The edges look slightly rough when you're right up at it, but when you're any more than just a few inches away, it...